A pair of the special holders used on DS 460 for holding blades with high clamping force.

These holders will register in the recesses cast into the table surface of DS 460, to define the alignment and the spacing of the holders.

Hence the blade is pre-set for quick blade changing. This pair of holders is identical to the pair included as standard with the DS 460.

Included components:

• Two blade holders, each complete with parallel-headed screw, nut and washer.
• Blister packed.

Technical specifications

• Forged steel holders with parallel-headed M4 clamp screws, nuts and washers. 
•  The holders are shaped to fit the aligning recesses cast into the table of DS 460